Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Aug 22, 2017 8:24 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Oct 19, 2016 1:53 am 

Joined: Thu Apr 16, 2015 6:22 am
Posts: 3
I do a good amount of contour cutting with Scal 3. I have the uscutter laserpoint 2 cutter.
I problem that I have had for awhile is that when I am done lining up reg marks 1 and 2 and go to line up 3 the software has a glitch and will not line up. I push down arrow and it goes up. In the past I would restart the machine and it would fix it


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group