Craft Edge
http://forum.surecutsalot.com/

Cutter Settings Import/Export
http://forum.surecutsalot.com/viewtopic.php?f=8&t=42932
Page 1 of 1

Author:  ButchZ [ Fri Feb 16, 2018 5:24 pm ]
Post subject:  Cutter Settings Import/Export

Its been quite awhile since ive been here at the forums, but for the wish list I am requesting cutter settings import/export instead of having to write down all my calibration settings from paper.
It would be nice to back up the settings and if a system restore, which I just went through, I had to manually enter them again.

This feature would also be nice in the cutter setting for blades/pen tools for material pressure/speeds/ etc.

Attachments:
SCAL - Cutter Settings 01.png
SCAL - Cutter Settings 01.png [ 115.06 KiB | Viewed 621 times ]

Author:  ButchZ [ Fri Feb 16, 2018 5:44 pm ]
Post subject:  Re: Cutter Settings Import/Export

Also, the custom presets export/import file would be nice too!

Attachments:
SCAL - Custom Presets.png
SCAL - Custom Presets.png [ 165.8 KiB | Viewed 621 times ]

Author:  klkitchens [ Fri Jul 06, 2018 9:40 am ]
Post subject:  Re: Cutter Settings Import/Export

And mat settings too while we're at it :)

Author:  SandyMcC [ Fri Jul 06, 2018 9:27 pm ]
Post subject:  Re: Cutter Settings Import/Export

The presets can be backed up. But maybe that was within one version. But you know... I really should put together a table that shows what can be backed up and what should be written down. I like that you posted all of these because it starts a list of things for me to look into. But it would be nice to just have one big file of baked up settings that covers the sizing calibration, preferred reg mark settings, PNC calibrations, workspace settings and, of course, cutting presets.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/