Cutter Settings Import/Export
Posted: Fri Feb 16, 2018 5:24 pm
Its been quite awhile since ive been here at the forums, but for the wish list I am requesting cutter settings import/export instead of having to write down all my calibration settings from paper.
It would be nice to back up the settings and if a system restore, which I just went through, I had to manually enter them again.
This feature would also be nice in the cutter setting for blades/pen tools for material pressure/speeds/ etc.
It would be nice to back up the settings and if a system restore, which I just went through, I had to manually enter them again.
This feature would also be nice in the cutter setting for blades/pen tools for material pressure/speeds/ etc.