Craft Edge

Sure Cuts A Lot Forum
It is currently Thu Jun 21, 2018 2:40 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Fri Feb 16, 2018 5:24 pm 

Joined: Wed Oct 25, 2017 6:11 am
Posts: 14
Its been quite awhile since ive been here at the forums, but for the wish list I am requesting cutter settings import/export instead of having to write down all my calibration settings from paper.
It would be nice to back up the settings and if a system restore, which I just went through, I had to manually enter them again.

This feature would also be nice in the cutter setting for blades/pen tools for material pressure/speeds/ etc.


Attachments:
SCAL - Cutter Settings 01.png
SCAL - Cutter Settings 01.png [ 115.06 KiB | Viewed 291 times ]
Top
 Profile  
 
PostPosted: Fri Feb 16, 2018 5:44 pm 

Joined: Wed Oct 25, 2017 6:11 am
Posts: 14
Also, the custom presets export/import file would be nice too!


Attachments:
SCAL - Custom Presets.png
SCAL - Custom Presets.png [ 165.8 KiB | Viewed 291 times ]
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group