Cutter Settings Import/Export

Tell us the features you want to see in Sure Cuts A Lot
Post Reply
ButchZ
Posts: 19
Joined: Wed Oct 25, 2017 6:11 am

Cutter Settings Import/Export

Post by ButchZ »

Its been quite awhile since ive been here at the forums, but for the wish list I am requesting cutter settings import/export instead of having to write down all my calibration settings from paper.
It would be nice to back up the settings and if a system restore, which I just went through, I had to manually enter them again.

This feature would also be nice in the cutter setting for blades/pen tools for material pressure/speeds/ etc.
Attachments
SCAL - Cutter Settings 01.png
SCAL - Cutter Settings 01.png (115.06 KiB) Viewed 1605 times

ButchZ
Posts: 19
Joined: Wed Oct 25, 2017 6:11 am

Re: Cutter Settings Import/Export

Post by ButchZ »

Also, the custom presets export/import file would be nice too!
Attachments
SCAL - Custom Presets.png
SCAL - Custom Presets.png (165.8 KiB) Viewed 1605 times

klkitchens
Posts: 17
Joined: Wed Sep 27, 2017 7:33 am

Re: Cutter Settings Import/Export

Post by klkitchens »

And mat settings too while we're at it :)

SandyMcC
Posts: 838
Joined: Mon May 09, 2011 7:01 am

Re: Cutter Settings Import/Export

Post by SandyMcC »

The presets can be backed up. But maybe that was within one version. But you know... I really should put together a table that shows what can be backed up and what should be written down. I like that you posted all of these because it starts a list of things for me to look into. But it would be nice to just have one big file of baked up settings that covers the sizing calibration, preferred reg mark settings, PNC calibrations, workspace settings and, of course, cutting presets.
Sandy McCauley
Owner of http://www.iloveknk.com/

Post Reply