Craft Edge

I love my eClips 2 - but wish loading paper and paper support were stronger - something to think about for future machines?

Paper loading - as it is now, the mat is barely held by the roller until Load Mat is selected. It's almost a balancing act....I'd like to see the return of a button that allows you to move the mat up and down.

Also, many of us are short on craft space. My eClips is right at my right hand - but it has to be right on the edge of the desk in order to allow room for the mat to move back. How about adding a pull-out tray in the front to hold the mat up while cutting at the top of the mat.

Just some thoughts.

Camille

I agree! unfortunately I do not think the Sizzix people look at this forum! this should go to the Sizzix forum and their customer support folks.

Let us know if u get a reply,

Here's one for the Wish List ...

I wish Craftedge would maintain an up to date Changelog of all new versions.

webtrekker wrote:Here's one for the Wish List ...

I wish Craftedge would maintain an up to date Changelog of all new versions.

I agree with you 100%.