Craft Edge
http://forum.surecutsalot.com/

cutting ruler lines
http://forum.surecutsalot.com/viewtopic.php?f=75&t=41167
Page 1 of 1

Author:  kpattondesigns [ Thu Jun 25, 2015 7:29 pm ]
Post subject:  cutting ruler lines

Hi
I am trying to "cut" the lines and numbers for a Growth Chart Ruler. I want it to measure 6', I also want it to include
the 11 lines between each foot.

my issue is the lines do not match up as exact/true measurements when comparing it to a measuring tape.
the more "feet" I add the measurements get "off kilter" and by the end of the 6' it is totally off exact/true measurement.

Can you help me understand how to get a "cut" with "inch lines" that will measure 72" or 84" and be exact?

I hope I explained that correctly and intelligently.
thank you

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/