Names on throw-away Drink Cups
Posted: Fri Dec 14, 2012 2:13 pm
Hi, just sharing what I've done so far to get ready for my family Christmas (other than gift shopping of course)
Once everyone leaves the house and patio are littered with drink cups. It seems like they get "lost", so just get another. My solution: I bought these large throw-away plastic cups. I had some white contact paper and went to work.
Font is Thick Chocolate. I tested a strip of paper to ensure size would wrap without a problem and found 4.5x2" worked. Drew the 4.5x 2 rectangle in ecal and filled in the names welded to be one piece. This made it easier to lift off the mat as I only had to lift the rectangle and separate the inner name.
I think the contact paper would work on glass and could be peeled off after use, but didn't try that yet.
I may get a bit more creative later and add a graphic, but this was one project to check of my TO DO list.
Happy Holidays with less trash!
Once everyone leaves the house and patio are littered with drink cups. It seems like they get "lost", so just get another. My solution: I bought these large throw-away plastic cups. I had some white contact paper and went to work.
Font is Thick Chocolate. I tested a strip of paper to ensure size would wrap without a problem and found 4.5x2" worked. Drew the 4.5x 2 rectangle in ecal and filled in the names welded to be one piece. This made it easier to lift off the mat as I only had to lift the rectangle and separate the inner name.
I think the contact paper would work on glass and could be peeled off after use, but didn't try that yet.
I may get a bit more creative later and add a graphic, but this was one project to check of my TO DO list.
- cup contact paperPS.jpg (46.45 KiB) Viewed 2734 times