Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Jun 28, 2017 9:43 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Mon Sep 12, 2016 7:24 am 

Joined: Mon Sep 12, 2016 7:07 am
Posts: 2
When I cut layers of an object at the same size and am sure to "keep proportions" when I go to apply them onto my fabric with the heat press I get a slight variation between the two colors and you can see my fabric between the layers. Not much but just enough to make it look bad in my opinion. I cannot get the layers to butt up perfectly.


Attachments:
image (3).jpg
image (3).jpg [ 42.4 KiB | Viewed 957 times ]
Top
 Profile  
 
PostPosted: Fri Sep 16, 2016 9:35 am 

Joined: Wed Dec 01, 2010 4:29 pm
Posts: 1964
Location: Sandy in PA (PC&MAC,Inkscape .48, SCAL2,eClips, eCAL)
Not sure, but gonna take a try at this. Is it possible that since the fabric can stretch somewhat that this is what is happening when applied? When looking at your picture, it appears the cuts are quite good.

_________________
Sandy in PA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group