Not exactly a cutting project, but...
Posted: Fri May 26, 2017 4:40 am
I recently bought a Silver Bullet cutter, but haven't done much cutting yet. We are mostly still experimenting.
- At first we just sent the mat and paper through, but most cuts would not be precise.
- Then I tried to straighten out the mat while cutting, and this was much better!
- Today I started to make a more permanent solution, and although it is a little rough in the edges and it isn't finished yet, I like it a lot 
The cutter is now placed ~12cm below the table, which ensures that the mat is horizontal at all times. By moving it away from the wall, I can also use my 60x90cm mat without problems.
- At first we just sent the mat and paper through, but most cuts would not be precise.
- WP_20170526_13_08_38_Rich_LI.jpg (111.81 KiB) Viewed 11950 times
- WP_20170526_13_09_35_Rich_LI.jpg (121.69 KiB) Viewed 11950 times
The cutter is now placed ~12cm below the table, which ensures that the mat is horizontal at all times. By moving it away from the wall, I can also use my 60x90cm mat without problems.
- WP_20170526_13_41_07_Rich_LI.jpg (131.98 KiB) Viewed 11950 times