Craft Edge

Sure Cuts A Lot Forum
It is currently Fri Mar 23, 2018 10:38 am

All times are UTC - 8 hours

Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Fri May 26, 2017 4:40 am 

Joined: Sat May 20, 2017 7:36 am
Posts: 16
I recently bought a Silver Bullet cutter, but haven't done much cutting yet. We are mostly still experimenting.

- At first we just sent the mat and paper through, but most cuts would not be precise.
WP_20170526_13_08_38_Rich_LI.jpg [ 111.81 KiB | Viewed 646 times ]

- Then I tried to straighten out the mat while cutting, and this was much better!
WP_20170526_13_09_35_Rich_LI.jpg [ 121.69 KiB | Viewed 646 times ]

- Today I started to make a more permanent solution, and although it is a little rough in the edges and it isn't finished yet, I like it a lot :)
The cutter is now placed ~12cm below the table, which ensures that the mat is horizontal at all times. By moving it away from the wall, I can also use my 60x90cm mat without problems.
WP_20170526_13_41_07_Rich_LI.jpg [ 131.98 KiB | Viewed 646 times ]

PostPosted: Fri Jun 09, 2017 1:38 pm 

Joined: Tue May 27, 2008 9:01 am
Posts: 2042
Location: NW Indiana
Glad you found a solution to your problem. :)

SCAL1, SCAL2 V2.044, SCAL3. SCAL4 XPsp3, Windows 7, Windows 10-64 bit, Ink.46, Cricut E, Silhouette Cameo
***My files are not to be sold and are for personal use only.***

PostPosted: Tue Jun 20, 2017 9:43 pm 

Joined: Tue Jun 20, 2017 9:38 pm
Posts: 4
I have a Titan and I cut glitter vinyl at 200g force and speed anywhere from 200-450


Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group