Craft Edge

Completely new and clueless
Page 1 of 1

Author:  jillian15279 [ Fri Jan 25, 2019 10:46 am ]
Post subject:  Completely new and clueless

Hi all. I just purchased a US Cutter SC2 and the sure cuts a lot pro 4 and have been trying to get my cutter to work via sure cuts a lot to my Mac. I contacted the company last night and they informed me that I would need the sure cuts a lot 5 since my system is 64 bit. that's done and I still can't find a driver for my cutter or find a way to get it to work.. So am I just completely clueless or out of luck using my Mac? if Im clueless can someone please fill me in so I can start playing soon...

Author:  SandyMcC [ Sat Jan 26, 2019 9:12 am ]
Post subject:  Re: Completely new and clueless

I have written a detailed SCAL5 user manual that should help you with this and other questions as you learn to use your cutter and SCAL5. So, have a look here first and then post additional questions if you cannot find what you need: ... l-support/

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group