Craft Edge

Sure Cuts A Lot Forum
It is currently Mon Oct 22, 2018 4:34 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Jul 19, 2018 3:16 pm 

Joined: Thu Jul 19, 2018 3:06 pm
Posts: 1
Hi there. I'm new to the Forum & just purchased the upgrade from SCAL V4 to V5. Is there any rules I should follow when installing the upgrade or do I just install over the previous version. I've tried to find some info on how to install the upgrade correctly but have had no luck & have run out of time to look.


Top
 Profile  
 
PostPosted: Thu Jul 19, 2018 9:50 pm 

Joined: Mon May 09, 2011 7:01 am
Posts: 420
Actually, SCAL5 will install into it's own folder which is really nice because it gives you the chance to go back and open SCAL4 in case you think there are any problems with 5. As a tester this was VERY convenient for me. Note that 4 and 5 share the same library and a few other custom things. But if you did any calibration for your cutter such as a sizing calibration or print and cut calibrations you will most likely need to input those numbers directly into SCAL 5.

If you have more questions or need help with anything, please also post if you are on a Mac or PC and which cutter you use for cutting. Thanks!

Sandy

_________________
Sandy McCauley
Manager of Customer Relations and Education for KNK USA
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group