Craft Edge
http://forum.surecutsalot.com/

New today
http://forum.surecutsalot.com/viewtopic.php?f=61&t=42955
Page 1 of 1

Author:  Madsgran [ Sat Mar 10, 2018 4:57 am ]
Post subject:  New today

Hi Everyone, I have the Scan n Cut and was recommended SCAL4. I have downloaded the trial version to have a play before I purchase.
I looked at the FAQ and I've looked at some videos. I wanted to do words on a path and on an arch but, when I click on the T all I get is tracking and width etc but not the ones I want. Is it because it's the trial version? Hope you can help as the software looks very interesting.
Many thanks x

Author:  SandyMcC [ Sat Mar 10, 2018 6:42 am ]
Post subject:  Re: New today

You should be able to try out these functions in the trial version. Here's a link to a detailed user manual I've written for SCAL4. It will help you learn how to type out text. There are lots of effects in SCAL4 that will allow you modify text. Some of those are covered in the Text chapter but also check out some of the others that can be applied to text in the Designing chapter. If you run into issues with any of these, feel free to post back with details and questions and I'll help you.

http://www.iloveknk.com/support/sure-cu ... l-support/

Author:  Madsgran [ Sat Mar 10, 2018 1:09 pm ]
Post subject:  Re: New today

Thank you so much Sandy, what an amazing resource. I have found my answer, was just clicking not holding my mouse button down.
Am looking forward to working through the chapters, thank you for your hard work. X

Author:  SandyMcC [ Sun Mar 11, 2018 8:16 am ]
Post subject:  Re: New today

You're welcome! So happy to know that it helped!

Author:  ebonylorange [ Wed Jul 17, 2019 4:26 am ]
Post subject:  Re: New today

Thank you for such informative discus .

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/