Craft Edge

Sure Cuts A Lot Forum
It is currently Mon Oct 15, 2018 7:46 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Nov 26, 2017 9:35 am 

Joined: Sun Nov 26, 2017 9:31 am
Posts: 1
Hi,

I've purchased the above. When I use the trace button and starting to add bridges or any other function - it is freezing, and showing not responding....it stays like that for a while then it works again. After every function, it freezes.

It is not my computer as all my other programs work just fine.

Please advise if any advice?

Thanks


Top
 Profile  
 
PostPosted: Mon Feb 05, 2018 5:05 am 

Joined: Sun Feb 04, 2018 12:19 pm
Posts: 2
Hey Jacky,
Did you ever figure anything out with this?

Just a couple of thoughts - how many other programs do you have open when you're trying to use SCAL4? I'm guessing that the new software is much larger than previous versions and is probably taking up much more memory than before. Try closing everything except SCAL4 and see what happens.

Frances


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group