Craft Edge

Sure Cuts A Lot4 - Not Responding
Page 1 of 1

Author:  JackyDeKlerk [ Sun Nov 26, 2017 9:35 am ]
Post subject:  Sure Cuts A Lot4 - Not Responding


I've purchased the above. When I use the trace button and starting to add bridges or any other function - it is freezing, and showing not stays like that for a while then it works again. After every function, it freezes.

It is not my computer as all my other programs work just fine.

Please advise if any advice?


Author:  Francesc [ Mon Feb 05, 2018 5:05 am ]
Post subject:  Re: Sure Cuts A Lot4 - Not Responding

Hey Jacky,
Did you ever figure anything out with this?

Just a couple of thoughts - how many other programs do you have open when you're trying to use SCAL4? I'm guessing that the new software is much larger than previous versions and is probably taking up much more memory than before. Try closing everything except SCAL4 and see what happens.


Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group