Craft Edge

FCM extenstion
Page 1 of 1

Author:  Sweetness4713 [ Tue Apr 18, 2017 1:48 pm ]
Post subject:  FCM extenstion

Hi everyone. It's been a while sinces I've been here.. I just became a new owner of the CM350 ScanNCut 2 .. What happened is I played with the brother software before getting the machine and used Sure cuts a lot 4 to open all my files.. Thus converting my main item used to open the fcm files to SCAL.. I have windows 10. How on earth to I revert back to not using SCAL to open them. .because what is happening is I'm saving them to my USB and the machine doesn't recognize them :(..

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group