Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Jul 26, 2017 10:49 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu Mar 09, 2017 11:18 am 

Joined: Thu Mar 09, 2017 10:15 am
Posts: 4
Hello,

I am a new Silhouette Cameo user (just purchased last Dec) and after wrestling unsuccessfully with the software, I purchased SCAL 4 Pro yesterday. This morning I attempted my first Print and Cut and encountered the following issues:

1. Silhouette will not find registration marks
2. SCAL crashes when I get to the print and cut settings menu and select "cut" or "detect marks manually"
3. I managed to get Silhouette to find my marks and cut once. I went over the marks with a sharpie, placed the paper flush with the top of the mat. However, the cuts were about 1/4" off.

I don't have a major project on the mat. Just some rectangles filled with a pattern to do a test run; and I'm running the Cameo with firmware version 1.4.

Any suggestions as to what I might be doing wrong?

Thank you so much!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group