SCAL 4 Pro Sillhouette Cameo Print & Cut Issues
Posted: Thu Mar 09, 2017 11:18 am
Hello,
I am a new Silhouette Cameo user (just purchased last Dec) and after wrestling unsuccessfully with the software, I purchased SCAL 4 Pro yesterday. This morning I attempted my first Print and Cut and encountered the following issues:
1. Silhouette will not find registration marks
2. SCAL crashes when I get to the print and cut settings menu and select "cut" or "detect marks manually"
3. I managed to get Silhouette to find my marks and cut once. I went over the marks with a sharpie, placed the paper flush with the top of the mat. However, the cuts were about 1/4" off.
I don't have a major project on the mat. Just some rectangles filled with a pattern to do a test run; and I'm running the Cameo with firmware version 1.4.
Any suggestions as to what I might be doing wrong?
Thank you so much!
I am a new Silhouette Cameo user (just purchased last Dec) and after wrestling unsuccessfully with the software, I purchased SCAL 4 Pro yesterday. This morning I attempted my first Print and Cut and encountered the following issues:
1. Silhouette will not find registration marks
2. SCAL crashes when I get to the print and cut settings menu and select "cut" or "detect marks manually"
3. I managed to get Silhouette to find my marks and cut once. I went over the marks with a sharpie, placed the paper flush with the top of the mat. However, the cuts were about 1/4" off.
I don't have a major project on the mat. Just some rectangles filled with a pattern to do a test run; and I'm running the Cameo with firmware version 1.4.
Any suggestions as to what I might be doing wrong?
Thank you so much!