Starbucks logo

Post Reply
DaiseyDrmr
Posts: 55
Joined: Sun Dec 20, 2009 1:58 pm

Starbucks logo

Post by DaiseyDrmr »

I've never uploaded a file before so I hope this works out okay. My DH helped me create this today and it cuts fantastically. It is about 5" wide when assembled so it may be too big for some projects.
Attachments
These are all the pieces in the file. You will have to carefully add the inside letters of A, R, B, and O. You will also have to add the tiny black piece in the crown, the nose and mouth. If you prefer to draw them in it might save you some time, but I wanted to keep the same layered look throughout. You just need a fine tip glue pen and tweezers. It was really pretty easy.
These are all the pieces in the file. You will have to carefully add the inside letters of A, R, B, and O. You will also have to add the tiny black piece in the crown, the nose and mouth. If you prefer to draw them in it might save you some time, but I wanted to keep the same layered look throughout. You just need a fine tip glue pen and tweezers. It was really pretty easy.
All pieces cut.jpg (78.94 KiB) Viewed 2599 times
This is what it looks like when it is assembled.
This is what it looks like when it is assembled.
assembled.jpg (72.37 KiB) Viewed 2599 times
Starbucks logo.scut2
This was created with SCAL 2.
(61.17 KiB) Downloaded 284 times
Post Reply