Silhouette Cameo 3

For your help and questions
Post Reply
lorieverhart
Posts: 6
Joined: Sun Dec 15, 2019 2:02 pm

Silhouette Cameo 3

Post by lorieverhart »

I have been a long time MTC user and am a creature of habit. Very scary to move into the world of SCAL, but I am EXCITED. Is SCAL compatible with Cameo 3?
Thank you and I look forward to learning a lot from this group.
Last edited by lorieverhart on Sat Dec 21, 2019 2:22 pm, edited 2 times in total.
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: Silhouette Portrait

Post by SandyMcC »

Yes! Both the Portrait and Portrait 2 are listed in the cutter menu where you select which cutter you'll be using.

Here's a link to the SCAL5 user manual that I wrote:

https://www.iloveknk.com/0um/SCAL5/SCAL ... Manual.pdf

And you might also find this useful since you're a long time MTC owner. It will help you find equivalent functions in SCAL that were using in MTC:

https://www.iloveknk.com/Support/Tutori ... nology.pdf
Sandy McCauley
Owner of http://www.iloveknk.com/
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: Silhouette Portrait

Post by SandyMcC »

Yes, SCAL5 is compatible with the Cameo 3 and even the new Cameo 4.
Sandy McCauley
Owner of http://www.iloveknk.com/
lorieverhart
Posts: 6
Joined: Sun Dec 15, 2019 2:02 pm

Re: Silhouette Portrait

Post by lorieverhart »

SandyMcC wrote:Yes, SCAL5 is compatible with the Cameo 3 and even the new Cameo 4.
Thank you :)
lorieverhart
Posts: 6
Joined: Sun Dec 15, 2019 2:02 pm

Re: Silhouette Portrait

Post by lorieverhart »

SandyMcC wrote:Yes! Both the Portrait and Portrait 2 are listed in the cutter menu where you select which cutter you'll be using.

Here's a link to the SCAL5 user manual that I wrote:

https://www.iloveknk.com/0um/SCAL5/SCAL ... Manual.pdf

And you might also find this useful since you're a long time MTC owner. It will help you find equivalent functions in SCAL that were using in MTC:

https://www.iloveknk.com/Support/Tutori ... nology.pdf
Thank you!
Post Reply