Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Feb 18, 2020 10:39 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Silhouette Cameo 3
PostPosted: Sun Dec 15, 2019 3:33 pm 

Joined: Sun Dec 15, 2019 2:02 pm
Posts: 3
I have been a long time MTC user and am a creature of habit. Very scary to move into the world of SCAL, but I am EXCITED. Is SCAL compatible with Cameo 3?
Thank you and I look forward to learning a lot from this group.


Last edited by lorieverhart on Sat Dec 21, 2019 2:22 pm, edited 2 times in total.

Top
 Profile  
 
 Post subject: Re: Silhouette Portrait
PostPosted: Mon Dec 16, 2019 8:58 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 778
Yes! Both the Portrait and Portrait 2 are listed in the cutter menu where you select which cutter you'll be using.

Here's a link to the SCAL5 user manual that I wrote:

https://www.iloveknk.com/0um/SCAL5/SCAL ... Manual.pdf

And you might also find this useful since you're a long time MTC owner. It will help you find equivalent functions in SCAL that were using in MTC:

https://www.iloveknk.com/Support/Tutori ... nology.pdf

_________________
Sandy McCauley
Owner of http://www.iloveknk.com/


Top
 Profile  
 
 Post subject: Re: Silhouette Portrait
PostPosted: Tue Dec 17, 2019 2:56 pm 

Joined: Mon May 09, 2011 7:01 am
Posts: 778
Yes, SCAL5 is compatible with the Cameo 3 and even the new Cameo 4.

_________________
Sandy McCauley
Owner of http://www.iloveknk.com/


Top
 Profile  
 
 Post subject: Re: Silhouette Portrait
PostPosted: Sat Dec 21, 2019 2:22 pm 

Joined: Sun Dec 15, 2019 2:02 pm
Posts: 3
SandyMcC wrote:
Yes, SCAL5 is compatible with the Cameo 3 and even the new Cameo 4.

Thank you :)


Top
 Profile  
 
 Post subject: Re: Silhouette Portrait
PostPosted: Sun Dec 22, 2019 8:39 am 

Joined: Sun Dec 15, 2019 2:02 pm
Posts: 3
SandyMcC wrote:
Yes! Both the Portrait and Portrait 2 are listed in the cutter menu where you select which cutter you'll be using.

Here's a link to the SCAL5 user manual that I wrote:

https://www.iloveknk.com/0um/SCAL5/SCAL ... Manual.pdf

And you might also find this useful since you're a long time MTC owner. It will help you find equivalent functions in SCAL that were using in MTC:

https://www.iloveknk.com/Support/Tutori ... nology.pdf


Thank you!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group