Hi everyone, Yesterday, I had a very simple item tu cut. I was wondered that two dashed lines were not cutted. They are good vissible at the screen, but not cutted. I tought, I wil transform the design and set "bottom on top". Same result: the same two dashed lines will not cut. Who can help me?
herewith a picture of the design. It were the two upper dashed line , they wil not cut).
Scal5/pro
Re: Scal5/pro
Sorry I missed seeing your post last week.
The only way for me to answer the question is to see the file myself. But it's probably just easier if I remake the file for you. I'll do that and post here in a bit.
The only way for me to answer the question is to see the file myself. But it's probably just easier if I remake the file for you. I'll do that and post here in a bit.
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/
Re: Scal5/pro
Here's a new version I traced from scratch. Let me know if it fails to cut all of the dashed lines.
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/