Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl Roll

SandyMcC · Post by **SandyMcC** » Mon Jun 03, 2019 4:26 am

It appears to me that "HIT" and "THE" are not the same Height. When you select each and look at the H value on the Size & Position panel, are they the same?

Wind Gatherer · Post by **Wind Gatherer** » Mon Jun 03, 2019 12:12 pm

SandyMcC wrote:It appears to me that "HIT" and "THE" are not the same Height. When you select each and look at the H value on the Size & Position panel, are they the same?

Is getting quite late here in UK. I'll try to look at this Tuesday and get back to you.
Thanks, once more

Wind Gatherer · Post by **Wind Gatherer** » Tue Jun 04, 2019 12:37 pm

Yes words are different sizes, see attached. I assume if I change HIt to the same size as THE, the issue will be solved?
Thank you.

SandyMcC · Post by **SandyMcC** » Wed Jun 05, 2019 6:05 am

Since I've never fully understand what the final result/project will be, I can't answer your question. In general, people just type out letters, set the size of the overall text (height or width) to what they need and then cut them out. In your case, it seems you're needing something very specific that I don't fully grasp. Sorry! If you have an example of what you're trying to achieve, feel free to post it and then maybe I can help some more.

Craft Edge

Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl Roll

Re: Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl R

Re: Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl R

Re: Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl R

Re: Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl R

Re: Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl R

Re: Setting Up 2 Parallel Rows Of Words To Be Cut On Vinyl R