Cutting Lines across design

For your help and questions
Post Reply
DevilEleven11
Posts: 1
Joined: Thu Dec 27, 2018 12:26 pm

Cutting Lines across design

Post by DevilEleven11 »

Just purchased a used zing air from a friend. Have done all the calibration & setup stuff correctly i believe. Problem is I am getting a line across the design after it runs the design it comes back across and presses down for a line? Any suggestions?? All help would be appreciated. Thanks,
Attachments
IMG_1741.jpg
IMG_1741.jpg (125.72 KiB) Viewed 1249 times
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: Cutting Lines across design

Post by SandyMcC »

Did you purchase a registration number for SCAL and register it? That appears to be the "watermark" added when SCAL is in trial mode.
Sandy McCauley
Owner of http://www.iloveknk.com/
Post Reply