Craft Edge

Sure Cuts A Lot Forum
It is currently Fri Jan 18, 2019 9:32 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Dec 27, 2018 12:32 pm 

Joined: Thu Dec 27, 2018 12:26 pm
Posts: 1
Just purchased a used zing air from a friend. Have done all the calibration & setup stuff correctly i believe. Problem is I am getting a line across the design after it runs the design it comes back across and presses down for a line? Any suggestions?? All help would be appreciated. Thanks,


Attachments:
IMG_1741.jpg
IMG_1741.jpg [ 125.72 KiB | Viewed 95 times ]
Top
 Profile  
 
PostPosted: Fri Dec 28, 2018 6:30 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 486
Did you purchase a registration number for SCAL and register it? That appears to be the "watermark" added when SCAL is in trial mode.

_________________
Sandy McCauley
Manager of Customer Relations and Education for KNK USA
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group