Craft Edge

Sure Cuts A Lot Forum
It is currently Mon Oct 22, 2018 5:40 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Loading Mat
PostPosted: Sun Aug 26, 2018 4:07 pm 

Joined: Sun Aug 26, 2018 3:59 pm
Posts: 2
Hello! I had recently been using the cricut craft room with my cricut expressions to load the mat. I do not have any cartridges for it. So this was the only way I could load the mat then use SCAL2 to cut the design. Is there another program or another way to load the mat? The new design studio doesn't recognize the expressions and the cricut craft room is discontinued. I tried the original software cricut designstudio but it doesn't have a load mat feature either.

TLDR: How can I load the mat without a cartridge?


Top
 Profile  
 
 Post subject: Re: Loading Mat
PostPosted: Sun Aug 26, 2018 5:10 pm 

Joined: Sun Aug 26, 2018 3:59 pm
Posts: 2
Did a lot of searching and found a way how. I took a peice of cardboard and some wire and made the wire touch pins 2, 3, 5 then tied the other end of the wire all together which made it think the george and shapes v1.0 cartridge was in and now everything works fine.

Basically using this website just I used wire instead of aluminum foil. https://www.instructables.com/id/Make-y ... -for-free/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group