Craft Edge
http://forum.surecutsalot.com/

Issues with the new SCAL 5
http://forum.surecutsalot.com/viewtopic.php?f=6&t=43150
Page 1 of 1

Author:  Merch1 [ Mon Jul 09, 2018 1:59 am ]
Post subject:  Issues with the new SCAL 5

Hello everybody!

I updated to SCAL 5 and enjoy the new features. Thanks to Craft Edge! :-)

But unfortunately i have some issues:

Issue 1)
I created a complex design in SCAL 5 (Windows 10). At the end of my work SCAL 5 crashed. After restart of the computer and SCAL 5 the file couldn't load anymore. It comes an error message, that the file is broken. My work of 1 hour blowed away. :(

Issue 2)
SCAL 5 does not work correctly with my "PowerCut 740 BT" Plotter. I set up everything correctly. (Baud rate etc.) The Plotter is cutting but not with the adjustments (speed, blade pressure...). Sometimes only the fan begin to run, but the Plotter do nothing. In SCAL 4 i set up the Plotter as "US Plotter -> MH". With this assignment i have the same problems as described.

I hope you can help me! The new SCAL 5 version is awesome and i want to work with it.

Kind regards,
Lars

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/