Craft Edge

Sure Cuts A Lot Forum
It is currently Fri Oct 19, 2018 2:47 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: I NEED HELP PLEASE
PostPosted: Thu Feb 22, 2018 12:49 am 

Joined: Thu Feb 22, 2018 12:44 am
Posts: 1
honestly i dont know where im going tompost on what forum so i guess to create new , i have a problem with mg GCC I CRAFT cutter plotter
everytime i open it start on a middle so i cant cut a 12 inch WIDTH
I just cut a 9inch width, anyone can HELP ME PLEASE


Top
 Profile  
 
 Post subject: Re: I NEED HELP PLEASE
PostPosted: Thu Feb 22, 2018 8:22 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 414
Are you using Sure Cuts A Lot software? If so, can you open your project and then post a full screenshot of the Cut Settings window?

_________________
Sandy McCauley
Manager of Customer Relations and Education for KNK USA
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group