honestly i dont know where im going tompost on what forum so i guess to create new , i have a problem with mg GCC I CRAFT cutter plotter
everytime i open it start on a middle so i cant cut a 12 inch WIDTH
I just cut a 9inch width, anyone can HELP ME PLEASE
I NEED HELP PLEASE
Re: I NEED HELP PLEASE
Are you using Sure Cuts A Lot software? If so, can you open your project and then post a full screenshot of the Cut Settings window?
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/