Page 1 of 1

Uncentered Mat

Posted: Fri Feb 09, 2018 2:44 pm
by bdieges
I am trying to figure out how to match the centering of the mat with the screen view in SCAL. The screen view is perfectly centered, but when I put the mat through the Silhouette cutter the object to be cut is 1/2" off. However, if I an object in the Silhouette program it is right where it should be. I sent an email to support, and they helped me with getting the object in the correct horizontal position, but it still is not centered and I haven't heard back from them since then. Any ideas?