Craft Edge

Sure Cuts A Lot Forum
It is currently Sun Jun 17, 2018 8:06 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Uncentered Mat
PostPosted: Fri Feb 09, 2018 2:44 pm 

Joined: Tue Feb 06, 2018 3:50 pm
Posts: 1
I am trying to figure out how to match the centering of the mat with the screen view in SCAL. The screen view is perfectly centered, but when I put the mat through the Silhouette cutter the object to be cut is 1/2" off. However, if I an object in the Silhouette program it is right where it should be. I sent an email to support, and they helped me with getting the object in the correct horizontal position, but it still is not centered and I haven't heard back from them since then. Any ideas?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group