Page 1 of 1
Inserting a vector point into a path
Posted: Tue Aug 22, 2017 2:50 pm
by BillAggie
I've tried for about an hour to figure this out. I'm editing a flame decal. the imported vector is missing a few nodes I need to get smooth flowing flame pathways. Every other program I've used, you just go into NODE mode and double click to insert a cusp or other node. with SCALP4, I can't find a way to insert a node to save my butt!
Any sugestions?
Bill
Re: Inserting a vector point into a path
Posted: Tue Aug 22, 2017 5:16 pm
by papasue
Re: Inserting a vector point into a path
Posted: Tue Aug 22, 2017 8:26 pm
by BillAggie
I would have never found this had it not been for your answer! Thank you! Never expected the add a node feature to be in the drawing area. I actually follow the logic but everyone else puts it in the node tool.
Thank you!
Re: Inserting a vector point into a path
Posted: Sun Jul 08, 2018 11:28 pm
by petermichaels
Many many thanks for sharing with us.
visit my site :
https://www.clippingpathassociate.com