Craft Edge

Sure Cuts A Lot Forum
It is currently Sun Dec 17, 2017 3:59 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Wed Jul 12, 2017 4:15 am 

Joined: Thu Jun 22, 2017 6:24 am
Posts: 4
Hi

As the title says, no registration marks at all.

In the simple process of opening new, then I draw something (a saquare or a circle) then preview: check the button reg marks on (or on then off then on again) nothing in the preview except my object (the sqaure or the circle)

Same in the print command: I check the registration marks, no reg mark is printed except my square or circle.

I'm using SCAL 4.062 (not pro), with serial (activated). But I did not register (yet).

Do I have to do something to make those registration marks available? Calibrate?
My cutter is NOT connected to the computer yet.

Please help as this is blocking me in the process of creating the printing part of the job.
Many thx in advance


Top
 Profile  
 
PostPosted: Wed Jul 12, 2017 1:01 pm 

Joined: Sun Mar 16, 2008 2:08 pm
Posts: 4386
Location: CALIFORNIA
You have to register and activate the software, connect the cutter, set the cutter to yoursofteware. There are complete instruction on getting started on craftedge.com.

_________________
Susan E
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE


Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group