Hi,
I've been using a USCutter Laserpoint II with Sure Cuts A Lot 3 Pro and all is well. However, I just purchased a new Silhouette Cameo 3 to use for smaller projects because I thought SCAL3 would work with it as well. Unfortunately, it tells me the Silhouette is not found when I try and send the job. I know the Silhouette is working because it works fine with their Studio software.
So, has anyone got a Cameo 3 working with Sure Cuts a lot 3 Pro yet?
Thanks for the help!!
Brad
Has anyone got SCAL 3 working with the new CAMEO 3?
-
- Posts: 2
- Joined: Mon Jun 12, 2017 11:57 am
Re: Has anyone got SCAL 3 working with the new CAMEO 3?
CAMEO3 support was added in SCAL4
- Craft Edge
http://www.craftedge.com
http://www.craftedge.com