Craft Edge

Sure Cuts A Lot Forum
It is currently Thu Jan 23, 2020 11:40 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Aug 01, 2019 4:43 pm 

Joined: Thu Aug 01, 2019 4:38 pm
Posts: 1
Hello! I have a Cricut Expression. I am trying to figure out if there are any options to use SCAL with it. The issue is that at some point I updated its firmware (approx 2012 ish) so I'm running v 2.43. Do I need to have SCAL 2 to make it work, and will SCAL2 work with updated firmware? I downloaded SCAL 5 and the libcutter patch as instructed in a previous post and could not get it to work. Thanks!


Top
 Profile  
 
PostPosted: Fri Aug 02, 2019 6:56 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 751
SCAL5 and the patch should have worked. Did you also install the Windows or Mac driver for your Cricut?

Otherwise, to your current question, SCAL2 should also work, again, if you have the proper FTDI driver installed, as well. Unfortunately, if you find SCAL2 for sale, it's not supported by Craft Edge any longer... due to the law suit by Provo Craft.

Post back if you have more questions.

_________________
Sandy McCauley
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group