Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Oct 17, 2017 7:50 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Cutter or software?
PostPosted: Mon May 08, 2017 12:46 pm 

Joined: Mon May 08, 2017 12:39 pm
Posts: 1
When I cut large designs (24"x 18), many times, some of the lines in the design are getting shifted lower in random places (it's not like each line shifts at the same vertical spot). I am using SCAL Pro, cutting with a US Cutter Titan 2 using the roller. I am using a new computer, and keeping other programs closed while cutting. Some times I have probs, sometimes I don't. I am wasting too much vinyl. help, please!!!


Top
 Profile  
 
 Post subject: Re: Cutter or software?
PostPosted: Tue May 09, 2017 7:03 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 167
That's most likely an issue with the cutter itself. Make sure your cutting speed isn't too fast and also make sure everything is clean and there's no random stickiness on the pinch rollers or even on the bottom of the vinyl.

_________________
Sandy McCauley
Manager of Customer Relations and Education for KNK USA
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group