Screen & Mat out of calibration
Re: Screen & Mat out of calibration
Just installed the new version and still the same problem. Still have not heard anything from Craft Edge.
Re: Screen & Mat out of calibration
I did the same test this morning in hopes that the new version addressed it. I'll try sending an email.
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/
Re: Screen & Mat out of calibration
It finally occurred to me the source of this problem. Steve and I were both using the laser light to set the origin in WYSIWYG mode. That's not the way SCAL is written. The origin is based on the tip of the blade. Once I used the blade tip, the shapes were then cut in the correct location on the mat.
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/