moved SCAL2 to another computer and have questions

For your help and questions
Post Reply
mikewozowski
Posts: 6
Joined: Sun Jul 10, 2011 6:32 pm

moved SCAL2 to another computer and have questions

Post by mikewozowski »

when i try to cut something, it gets hung up on the initilazing phase. is there something i need to do?

i have been using SCAL2 on my old computer for years, but it would be easier if i could use it on my new computer. i can use it for design and stuff, but i can't get it to cut. :(

any ideas?

thanks!
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: moved SCAL2 to another computer and have questions

Post by SandyMcC »

Did you install the driver for your cutter onto this new computer?
Sandy McCauley
Owner of http://www.iloveknk.com/
mikewozowski
Posts: 6
Joined: Sun Jul 10, 2011 6:32 pm

Re: moved SCAL2 to another computer and have questions

Post by mikewozowski »

no, probably not. i watched a youtube video on how to do it, but i wasn't able to follow the directions. :(
mikewozowski
Posts: 6
Joined: Sun Jul 10, 2011 6:32 pm

Re: moved SCAL2 to another computer and have questions

Post by mikewozowski »

ok, i went to the craftedge site and downloaded the 2.4.2 usb driver package. installed it. tried it and the same thing happened. any other ideas or things i can check to see if i did it right or have what i need?

thank you for your help.
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: moved SCAL2 to another computer and have questions

Post by SandyMcC »

It's not easy to know what to say without verification of which cutter you even own. Or which operating system you're using on your computer. Maybe provide a lot more information and someone can give you better suggestions. I only use SCAL4 myself, but since this is tied to the driver, it should be more about the cutter and computer bands/models.
Sandy McCauley
Owner of http://www.iloveknk.com/
Post Reply