For your help and questions
3 posts • Page 1 of 1
- Posts: 1964
- Joined: Wed Dec 01, 2010 4:29 pm
- Location: Sandy in PA (PC&MAC,Inkscape .48, SCAL2,eClips, eCAL)
The machine can't....practically any software can. Not sure of your issue, however it looks like you are getting ragged cuts? It may just be your blade is getting worn or it could be the paper quality. I have sharpened blades in past by cutting through aluminum foil. It is a quick fix and doesn't last forever, but buys time til you order new blades (if that is the issue).
Sandy in PA
Do a test cut with a cartridge and see if you get the same results. But looks like the blade is the issue to me. Check for crack or paper stuck to it. Try slower setting. A lot of variables to try and isolate the issue.
http://classroom.scrappydew.com/courses ... r-training - SCAL Classroom over 40+ Videos geared towards beginners.