Craft Edge

Hi my name is Susan, I own a Pazzles Inspirations cutter and I use both the Pazzles software and Sure Cuts A Lot 3 Pro when I'm designing. I am in the process of starting a blog where I would like to share my designs both for free and for purchase. I realize in looking at others that share and sell there designs that there are a few file types that I will need to offer them in. I know that my basic Pazzles software will only open a WPC file and with my Sure Cuts A Lot I am able to use SVG files and I know that I have the option to save SVG files with it as well. I have several designs that I have done with my Pazzles software and I would like to save them a SVG files but I have had no luck in trying to open them in my Sure Cuts A Lot software. Can anyone help me with this or if you could send me in the right direction it would be greatly appreciated...

Thank you so much
Susan

Welcome, sorry I don't know...sending this to the top for an answer.

http://www.youtube.com/watch?v=6Y19HwP9IW8

I knew there was a way...here is a video to explain.

WPC is partially supported.
If you would like to try it out with your files, please install this one
http://www.craftedge.com/bin/SetupSureC ... 045wpc.exe

Thank you so much for your help I was able to get it to work...come on by and check out the my new blog and let me know if there were any problems with my file down load...

Thanks all again so much.

http://scrapyq.blogspot.ca/

Scrapy Q