Newest Update to SCAL 3.044

[scrapper1]

I downloaded the newest update to SCAL today & then it would not open at all on my computer. Windows said there was a problem with the program & shut it down.
I tried re-booting my computer to see if it would work & it did the same thing.
Is there a fix for this?
I re-installed 3.042 again until I know this is fixed.
Please advise!
Thanks
Kathy

[gj1]

Mine opens fine with Windows7. Perhaps try the d/l again...maybe you did not choose your correct operating system.

[dragonlord666]

re-download, it may just have been a bad download

Gaz

[Wendy]

I'm having the exact same issue with Windows 8...

I've done the Windows 8 driver thingy, I've uninstalled and reinstalled several times. I've confirmed my antivirus and firewall aren't causing problems. The program wasn't cutting certain font letters, so I decided maybe it was an update issue and decided to update in the middle of a project...big mistake! Now I have a project due to a customer today that I need to finish cutting and the program gets stuck on the "Init Interface" screen right after it loads the fonts.

[Wendy]

I'm having the same issue, but don't have 3.042 to revert to because I'm on a new computer, could you email me 3.042? I'd GREATLY appreciate it! Thanks! I'm extremely frustrated as a I have a Christmas gift I'm finishing up a friend asked me to make!

[gj1]

Type to support@craftedge.com
please.