OK...Just got the software. Installed. Can't import AI files...but that's OK.
The largest setting for the project area is 72".
Will the program allow something to be cut longer than the 72 inch project limit?
I have some long swooshes...about 18 feet for the side of a yogurt truck...Can I cut these?
Thanks,
Tim
Size that SCAL3 will actually cut
-
- Posts: 1964
- Joined: Wed Dec 01, 2010 4:29 pm
- Location: Sandy in PA (PC&MAC,Inkscape .48, SCAL2,eClips, eCAL)
Re: Size that SCAL3 will actually cut
Go to the cutter tab -- choose material size -- choose custom size -- put in the length you want.
Sandy in PA
Re: Size that SCAL3 will actually cut
For issues importing files, please email the file to support@craftedge.com so it can be tested.
For cutting 18 feet, you would need to use the Pro version of Sure Cuts A Lot
For cutting 18 feet, you would need to use the Pro version of Sure Cuts A Lot
- Craft Edge
http://www.craftedge.com
http://www.craftedge.com