Craft Edge
http://forum.surecutsalot.com/

Scut 4.040 print and cut function not working
http://forum.surecutsalot.com/viewtopic.php?f=46&t=41484
Page 1 of 1

Author:  PinkBloodCreations [ Mon Dec 28, 2015 3:47 pm ]
Post subject:  Scut 4.040 print and cut function not working

Is it just me, or is the print and cut function on Sure Cuts A Lot 4.040 not functioning. I've tried just about everything but nothing works. I can't even calibrate the laser of get the laser over all three marks, usually just the first and then it stops working, crashes.
Anyone know what I can do? I've contacted Support, but no reply :cry:

Author:  papasue [ Wed Dec 30, 2015 9:51 am ]
Post subject:  Re: Scut 4.040 print and cut function not working

I suggest you file a support request with craftedge.com directly. They will help you figure out what is going on. Report back here when you get it fixed so all of us will know too. They do not regularly visit this forum.

Author:  PinkBloodCreations [ Wed Dec 30, 2015 10:39 am ]
Post subject:  Re: Scut 4.040 print and cut function not working

Yeah, I did that before I posted this message, they haven't responded. I was hoping to find some answers from other users.

Anyway, I'll make sure to post whatever I find out here. Thank you

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/