Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Apr 25, 2017 4:27 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat Jul 27, 2013 3:33 am 

Joined: Mon Aug 27, 2012 3:11 am
Posts: 2
As in SCAL, there is no option for 'No Mat' like one in SSDE, cutting let's say 12" x 24" vinyl will cause not cut on the right edge or slip-through at the bottom if your design is filled the page.
Here I am attaching the picture of the size and placement that your design should be which you will have to leave 3 grids on the right and 6 grids at the bottom.

If you are cutting your design from its roll, then you can fill it to the bottom with no issue.


Attachments:
cutting vinyl with SCAL.JPG
cutting vinyl with SCAL.JPG [ 270.55 KiB | Viewed 1173 times ]
Top
 Profile  
 
PostPosted: Wed Jul 31, 2013 4:42 am 

Joined: Thu Feb 04, 2010 5:09 am
Posts: 141
Thank you, I did not know this.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group