Craft Edge
http://forum.surecutsalot.com/

converting regular font to stencil font
http://forum.surecutsalot.com/viewtopic.php?f=40&t=42954
Page 1 of 1

Author:  bjm53 [ Fri Mar 09, 2018 6:46 am ]
Post subject:  converting regular font to stencil font

Hi there everyone...I need some instructions on how to convert any regular font into a stencil font. Thank you for your help in advance. :)

Author:  SandyMcC [ Fri Mar 09, 2018 6:49 am ]
Post subject:  Re: converting regular font to stencil font

Open the SCAL4 UM that I wrote... top link here: http://www.iloveknk.com/support/sure-cu ... l-support/

Then go to Section 6.10. If you still need help, please post more questions.

Author:  bjm53 [ Fri Mar 09, 2018 7:43 am ]
Post subject:  Re: converting regular font to stencil font

Hi there, SandyMcC...thank you very much for your quick reply. It has been many years since I used my old cricut expression machine, so I thought I would give it a try again when a dear friend of mine asked if I could cut out a stencil for her. Even when I did use it way back then, I never accomplished getting past the "newbie" user level, so I still don't know much about my machine and how to use the sure cuts a lot 2 program. I have not updated to SCAL4 UM, because apparently it will not work with my old cricut expression machine. The last few days I have watched many videos on how to do this conversion, but that are all done with different machines and programs and are too confusing to me. I probably need to watch and listen all the videos to get more familiar with my machine and learn all the functions that it is able to do. Many thanks again,
Kindest regards,
bjm53

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/