Craft Edge

Deactivate A Machine
Page 1 of 1

Author:  blonde0ne [ Thu Oct 12, 2017 9:39 am ]
Post subject:  Deactivate A Machine

is there a way to deactivated computers you have registered for SCAL 3 pro
I need to clean out my computers. I cannot get any to register.
I need to install scalpro on a new computer, my main one crashed

Author:  SandyMcC [ Fri Oct 13, 2017 9:56 am ]
Post subject:  Re: Deactivate A Machine

You can deactivate by going to Help>Deactivate. However, assuming you have no access to the computer that crashed, you'll need to contact SCAL using their support system. OR you can deactivate on another computer is you're not using that one. Here's a link to contact SCAL:

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group