Problem since update

Things we need you to know
Post Reply
has2tri
Posts: 7
Joined: Fri Nov 23, 2012 12:05 am

Problem since update

Post by has2tri »

I have just done the update and since I did I can't cut anything.

I use an Ecutter and everything loads up fine then when I press the cut button it gets stuck on checking firmware

Anyone know of a solution to this?

Thanks

Shell
HeatherM
Posts: 3913
Joined: Sun Jan 11, 2009 7:16 am
Location: Michigan, SCAL1; SCAL2; eCAL; Windows7 64 bit; eCAL Mavericks
Contact:

Re: Problem since update

Post by HeatherM »

Do you have the "b" version of the update or the first version? If you have the first version try downloading the newest update. If that doesn't fix your problem then re-install the last version that worked for you. HTH
Post Reply