3D Ceratopsier Model

Post Reply
Louise-Paisley
Posts: 287
Joined: Sat Jun 16, 2012 4:36 pm

3D Ceratopsier Model

Post by Louise-Paisley »

Here is another one for you, again cut from 1mm matboard as sold by Dawn.

This one is a real brain teaser to assemble, fortunately the original file had most of the slots numbered so I have attached that for you too.

I think maybe some of the slots could do with being a bit longer to make it a bit more stable, I might re-work it eventually.

Here it is..
Attachments
Ceratopsier-1mm Mountboard-1.jpg
Ceratopsier-1mm Mountboard-1.jpg (109.29 KiB) Viewed 3494 times
Ceratopsier model help.svg
(530.96 KiB) Downloaded 356 times
Ceratopsier model.svg
(111.12 KiB) Downloaded 355 times
Software: Windows 7 (64 bit) - SCAL 3 - Inkscape - Illustrator CS4 - Signcut Pro
Cutter 1: Blackcat Cougar 24" connected via Keyspan/ serial
Cutter 2: Phoenix Silver Bullet Pro 24" connected via Keyspan/ serial
pastda3
Posts: 2044
Joined: Tue May 27, 2008 9:01 am
Location: NW Indiana

Re: 3D Ceratopsier Model

Post by pastda3 »

This is awesome, but there is no way I would want to tackle that. I don't have the patience.
SCAL1, SCAL2 V2.044, SCAL3. SCAL4 XPsp3, Windows 7, Windows 10-64 bit, Ink.46, Cricut E, Silhouette Cameo
***My files are not to be sold and are for personal use only.***
Louise-Paisley
Posts: 287
Joined: Sat Jun 16, 2012 4:36 pm

Re: 3D Ceratopsier Model

Post by Louise-Paisley »

pastda3 wrote:This is awesome, but there is no way I would want to tackle that. I don't have the patience.
Took about 5 or 10 mins tops to cut, and I would say roughly 15 minutes to assemble.
Software: Windows 7 (64 bit) - SCAL 3 - Inkscape - Illustrator CS4 - Signcut Pro
Cutter 1: Blackcat Cougar 24" connected via Keyspan/ serial
Cutter 2: Phoenix Silver Bullet Pro 24" connected via Keyspan/ serial
Post Reply