Need some help

Requests for finding a Font or Shape to use in Sure Cuts A Lot
Post Reply
cassandra
Posts: 143
Joined: Thu Apr 24, 2008 5:35 am

Need some help

Post by cassandra »

Hi,
I am trying to create a rounded edge rectangle .90w x 1.90 h and when I go to cut it, it only does certain areas and stops. I tried doing this in inkscape and not doing it well.

If you have a minute can you make me one? Thanks.
wreed06
Posts: 1434
Joined: Sat Feb 23, 2008 7:42 pm

Re: Need some help

Post by wreed06 »

Did you try the shapes in SCAL? Just before the stars in the shapes window, there are two squares. One square has square corners, the other has rounded corners. Choose the rounded corner square. Then in the properties box, you can enter the measurements. Make sure the Keep Proportions box is unchecked, enter .9 for the width and 1.9 for the height. I don't know what your .9 and 1.9 is though - inches, cms?
cassandra
Posts: 143
Joined: Thu Apr 24, 2008 5:35 am

Re: Need some help

Post by cassandra »

Yes I did, I finally figured it out and got the shape I need. Thank you.
Post Reply